Earlier this year the FAA updated the Private Pilot Test
Supplement. This is the book that contains all the figures and charts that are
referenced in the Private Pilot Knowledge Test. This introduced a number of
issues. One issue is that the scale on the sectional chart excerpts does not
match the scale on a real chart and consequentially your plotter can’t be used
to directly measure distance. The previous test supplement, although it didn’t
match perfectly, was relatively close. On the new test supplement, figure 21 is
significantly different than the normal scale. You can see in this picture that
if you used your plotter, a distance of 10 NM on the figure would be measured
as only 7 NM as shown on a plotter. This would be enough to throw any calculations
off and lead to answering the test question incorrectly. Each figure has a
unique scale on the side of the chart that must be carefully checked in order
to determine the accurate distance.
Friday, October 3, 2014
Friday, September 26, 2014
Letter "L"
It is intriguing what landmarks are charted on our sectional charts. On the San Francisco sectional chart in the northern area toward the coast, I found this interesting landmark. Normally you will see notes like settlement, ranch, sawmill, etc. But I haven't seen anything like this before.
This is what is found at this location.... Yep, that is an "L" marked on the ground. Now the mystery is why is it there. Well that is another story.
Friday, September 19, 2014
Interesting class B airspace
I ran across an interesting notation for the floor of a class B airspace. It is common to see notation that use "-" to indicate that a class D airspace goes up to but does not include an altitude. An example of this is KSQL class D airspace on the east side of the airport. It has a designation of [-15] which indicates that the Delta airspace goes up from the surface up to but not including 1500 MSL. It is also common to see "T" used for the ceiling of class C airport to indicate that the ceiling extends to the top of the overlying airspace. This is used in the KOAK class C airspace.
In the New York area, I ran across a unique notation that I hadn't seen before. One of the shelves of the class B had a notation of "+" for floor of the airspace. In the chart to the right, you can see the +05. This indicates that the floor of this airspace starts "above" 500 MSL but does not include 500 MSL.
In the New York area, I ran across a unique notation that I hadn't seen before. One of the shelves of the class B had a notation of "+" for floor of the airspace. In the chart to the right, you can see the +05. This indicates that the floor of this airspace starts "above" 500 MSL but does not include 500 MSL.
Friday, June 6, 2014
PIREPS Remarks
If you are checking PIREPS on a
regular basis you might notice some interesting text in the RM portions of a
PIREP. Here is an example:
FAT UA /OV CZQ040017/TM
1745/FL330/TP B737/TB LGT CHOP/RM AWC-WEB/SWA
In this case the RM section has
the text “AWC”. This is an indication that the PIREP was reported by a pilot
that has taken the SkySpotter training. The following comes from the FAA:
The
"SKYSPOTTER" program is a result of a recommendation from the Safer
Skies FAA/INDUSTRY Joint Safety Analysis and Implementation Teams. The term
"SKYSPOTTER" indicates that a pilot has received specialized training
in observing and reporting inflight weather phenomenon, pilot weather reports,
or PIREPs. When a PIREP from a pilot identifying themselves as a
"SKYSPOTTER" aircraft is received, the additional comment
"/AWC" must be added at the end of the remarks section of the PIREP.
You can find the AOPA SkySpotter
course here: http://flash.aopa.org/asf/skyspotter/
Subscribe to:
Posts (Atom)